Manganese Essentials™
Manganese plays an essential role in photosynthesis and adequate levels are critical for optimum plant production.
This key element is also critical for improving crop resilience. Manganese deficiencies are widespread particularly in light, sandy soils. Typical deficiency symptoms include interveinal chlorosis and, ultimately, reduced yield and increased disease susceptibility. Now you can address your manganese requirements with an ACO Registered Farm Input. Manganese Essentials™ contains 10.9% manganese organically chelated with fulvic acid and amino acids. This revolutionary mix of biological chelating agents improves plant uptake and assimilation of manganese.
Product Benefits
- Essential for the photosynthesis reaction
- Increase plant structural resistance & Improve crop stress tolerance
- Includes natural plant growth & microbial promotants
Typical Analysis W/V
| Manganese (Mn) | 10.96% |
| Total Nitrogen (N) (as organic) | 0.12% |
| Total Potassium (K) (as organic) | 0.13% |
| Sulfur (S) | 6.52% |
| Calcium (Ca) | 247 mg/L |
| Magnesium (Mg) | 352 mg/L |
| SG | 1.2 |
| pH | 2.5 - 3.5 |
| Conductivity | 35 - 55 mS/cm |
| Appearance | Brown Liquid |
Application Rates
| CROP | FOLIAR SPRAY RATE | FERTIGATION RATE | FREQUENCY |
|---|---|---|---|
| VEGETABLES | 0.5 L per 100 L water up to 2.5 L/ha equivalent | 3 – 7 L/ha | Twice prior to flowering or as required |
| ORCHARDS & VINEYARDS | 0.5 L per 100 L water up to 5 L/ha equivalent | 5 – 10 L/ha | Twice prior to flowering or as required |
| ORNAMENTALS | 0.5 L per 100 L water up to 3 L/ha equivalent | 3 – 7 L/ha | Twice prior to flowering or as required |
| TURF | 0.5 L per 100 L water up to 3 L/ha equivalent | 3 – 5 L/ha | Every 4 weeks or as required |
| BROADACRE CROPS | 1 – 2 L/ha in 80 – 100 L water, depending on canopy closure | N/A | Just prior to flowering or as required |
| PASTURE | 1 – 2 L/ha in 80 – 100 L water | N/A | As required |
| SPOT-SPRAYING | 25 mL per 10 L water | N/A | As required |
| SEED TREATMENT | 2 L/tonne of seed mixed with sufficient water to just coat the seed | ||
Stir well before use. Rates and frequencies should be adjusted according to crop monitoring. Where higher water rates are required for good foliar coverage, do not exceed maximum product rate per hectare. Sensitive foliage or plants should be test sprayed prior to full scale application. Ensure suitable spray conditions (e.g. temperature, humidity, wind- speed), prior to foliar application. Compatibility and/or performance cannot be guaranteed when combined with other products. Jar test for compatibility and spray test on small area before wide-spread use
Read safety directions before use. Store in a cool dry area out of direct sunlight. This product has been tested to store safely down to 5 o C. Crystallisation or sedimentation may occur below 5 o C. Do not pre-mix or store in diluted form. Seal lid/cap immediately after use
NOT COMPATIBLE WITH SOLUBLE CALCIUM OR PHOSPHATE BASED INPUTS. Avoid spraying close to harvest if produce is susceptible to staining. NOTE: Product in 1000 L tanks may weigh over 1 tonne. Forklift with 2 tonne lifting capacity is recommended
Online orders are only available within Australia. For international orders, please contact us.
Click here for detailed shipping information.
Any recommendations provided by Nutri-Tech Solutions Pty Ltd (NTS)
or its Distributors are advice only. As no control can be exercised over storage, handling, mixing, application or use, or weather, plant or soil conditions before, during or after application (all of which may affect the performance of our program), no responsibility for, or liability for any failure in performance, losses, damages, or injuries (consequential or otherwise), arising from such storage, mixing, application, or use will be accepted under any circumstances whatsoever. NTS recommend you contact an Agronomist prior to product application. The Buyer assumes all responsibility for the use of any NTS products.
You may also like
More from Farm Essentials
Recently viewed