39.4% pure calcium, without the tag-ons, can be immensely valuable when calcium is deficient. Calcium is the king of minerals.
A high-analysis source of micronised calcite combined in a free-flowing suspension with fulvic acid. Calcium is the trucker of all minerals and virtually all crops will benefit from a calcium supplement during the crop phase.
Key Performance
- This micronised liquid form of lime is easier to handle & faster acting than dry ag lime
- High analysis organic source of calcium for optimum crop quality
- Includes fulvic acid for enhanced crop response
Growth Stage
- Pre-planting
- Planting
- Vegetative Growth
- Pre-flower
- Flowering
- Fruit Set & Fill
Typical Analysis W/V
Calcium (Ca) | 39.37% |
Magnesium (Mg) | 1.05% |
SG | 1.6 |
pH | 8.6 – 9.6 |
Conductivity | 4 – 15 mS/cm |
Appearance | Thick, off-white/beige liquid, citrus odour |
Application Rates
CROP | FOLIAR SPRAY RATE | FREQUENCY |
---|---|---|
Vegetables | 1 L per 100 L water up to 5 L/ha equivalent | Apply weekly or as required |
Orchards & Vineyards | 1 L per 100 L water up to 7 L/ha equivalent | Apply every 2 – 4 weeks or as required |
Ornamentals & Turf | 1 L per 100 L water up to 5 L/ha equivalent | Apply every 2 – 4 weeks or as required |
Broadacre Crops | 2 – 3 L/ha in 60 – 100 L water, depending on canopy closure | Apply as required |
Pasture | 2 – 3 L/ha in 60 – 100 L water | Apply as required |
Spot-Spraying | 50 mL per 10 L water | Apply as required |
Home Garden Application: Dilute 45 mL per 9 L watering can and apply the diluted mix at a rate of 1 litre per square metre – this diluted mix can also be poured over foliage. Repeat every 2 - 4 weeks as required
Soil Ameliorant or Fertigation: Recommended application rate: 10 – 50 L/ha as required. Use a higher rate for soil amelioration.
Liquid Inject: Recommended application rate: 2 – 5 L/ha. Use a minimum dilution rate of 1 part product to 3 parts water. The rate will depend on crop, row spacing, and soil type. Always consider N and P crop requirements for starters based on reliable soil test data.
Shake or stir well before use and maintain constant agitation. It is advisable to pre-mix, adding this product slowly while maintaining agitation in spray tank to prevent settling of solids. Will pass through 200 micron filter under ideal conditions, however, a coarse inline filter (500 microns/35 mesh) is recommended to ensure the delivery lines are free from particle contaminants from other sources. Where higher water rates are required for good foliar coverage, do not exceed maximum product rate per hectare. MMS products will leave a visible residue on leaves and fruit when used as a foliar. Avoid spraying close to harvest if produce is susceptible to staining. Sensitive foliage or plants should be test sprayed prior to full scale application. Frequencies are a guideline only and can be adjusted according to farm practices and/or in conjunction with crop monitoring. Ensure suitable spray conditions (e.g. temperature, humidity, wind-speed), prior to foliar application. Compatibility and/or performance cannot be guaranteed when combined with other products. Jar test for compatibility and spray test on small area before wide-spread use
Store in a cool dry area out of direct sunlight. This product has been tested to store safely down to 5°C. Sedimentation may occur below 5°C. Do not pre-mix or store in diluted form. MMS products are very heavy and every care should be taken when handling these materials to avoid back injury
ACO RESTRICTED: Certified for use in organic agriculture when used according to the label instructions. (Do not exceed recommended rates)Note: Product in 1000 L tanks may weigh over 1 tonne. Forklift with 2 tonne lifting capacity is recommended
Online orders are only available within Australia. For international orders, please contact us.
Click here for detailed shipping information.
Any recommendations provided by Nutri-Tech Solutions Pty Ltd (NTS)
or its Distributors are advice only. As no control can be exercised over storage, handling, mixing, application or use, or weather, plant or soil conditions before, during or after application (all of which may affect the performance of our program), no responsibility for, or liability for any failure in performance, losses, damages, or injuries (consequential or otherwise), arising from such storage, mixing, application, or use will be accepted under any circumstances whatsoever. NTS recommend you contact an Agronomist prior to product application. The Buyer assumes all responsibility for the use of any NTS products.