Brix-Fix™
A concentrated fusion of natural chelators, PGPs, trace minerals, biostimulants and plant health enhancers.
Brix-Fix™ is a cost-effective yield builder for all crop production (fruit, vegetables and cereals). This breakthrough formulation involves seven proven plant growth promotants, including triacontanol, in a convenient, concentrated liquid. Foliar spray at just 2 L/ha for an impressive low-cost response. Also suitable as a ground application to promote beneficial soil biology and encourage strong, healthy growth.
Key Performance
- Promotes vigorous plant growth
- Relieves plant stress
- Boosts flowering
Growth Stage
- Planting
- Vegetative Growth
- Pre-flower
- Flowering
- Fruit Set & Fill
Typical Analysis W/V
| Natural acids, phenolic compounds, amino acids, 74 ocean derived trace minerals, cytokinins, gibberellins, auxins, betaines and mannitol | 17.5% |
| Total Nitrogen (N) | 0.26% |
| Total Potassium (K) | 1.65% |
| Sulfur (S) | 0.37% |
| Magnesium (Mg) | 0.15% |
| SG | 1.0 |
| pH | 5 – 5.8 |
| Conductivity | 30 – 50 mS/cm |
| Appearance | Brown liquid |
Application Rates
| Crop | Foliar Spray Rate | Frequency |
|---|---|---|
| Vegetables | 2 L/ha, repeat every 10 – 14 days or as required | 10 L/ha (fertigation), repeat monthly |
| Orchards & Vineyards | 2 L/ha, repeat monthly or as required | 10 L/ha (fertigation), repeat monthly |
| Broadacre Crops | 2 L/ha in 80 – 100 L of water, depending on canopy closure | 2 L/ha (liquid inject at planting) |
| Pasture | 2 L/ha in 80 – 100 L of water Allow 1 week before reintroducing stock to ensure foliage assimilation | 5 L/ha (irrigated pasture) |
| Spot-Spraying | 20 mL per 10 L water | Refer to above for spray frequency guide |
Hydroponics:
4 L per 50 L Part B OR 160 mL per 1000 L of final nutrient mix
Shake or stir well before use. Additional applications can be made immediately prior to or following stress periods such as frost or drought. It is preferable to increase the frequency of applications rather than the concentration of the solution. Where higher water rates are required for good foliar coverage, do not exceed maximum product rate per hectare. Sensitive foliage or plants should be test sprayed prior to full scale application. Frequencies are a guideline only and can be adjusted according to farm practices and/or in conjunction with crop monitoring. Ensure suitable spray conditions (e.g. temperature, humidity, wind- speed), prior to foliar application. Compatibility and/or performance cannot be guaranteed when combined with other products. Jar test for compatibility and spray test on small area before wide-spread use.
Store in a cool dry area out of direct sunlight. This product has been tested to store safely down to 5°C. Crystallisation or sedimentation may occur below 5°C. Do not pre-mix or store in diluted form. Seal lid/cap immediately after use
Not compatible with low pH solutions. Jar test to confirm compatibility. Avoid spraying close to harvest if produce is susceptible to staining. Note: Product in 1000 L tanks may weigh over 1 tonne. Forklift with 2 tonne lifting capacity is recommended
Online orders are only available within Australia. For international orders, please contact us.
Click here for detailed shipping information.
Any recommendations provided by Nutri-Tech Solutions Pty Ltd (NTS)
or its Distributors are advice only. As no control can be exercised over storage, handling, mixing, application or use, or weather, plant or soil conditions before, during or after application (all of which may affect the performance of our program), no responsibility for, or liability for any failure in performance, losses, damages, or injuries (consequential or otherwise), arising from such storage, mixing, application, or use will be accepted under any circumstances whatsoever. NTS recommend you contact an Agronomist prior to product application. The Buyer assumes all responsibility for the use of any NTS products.
You may also like
Recently viewed