Phos-Life Organic™

Phos-Life Organic™

Size
Regular price $133.85
/
Tax included. Shipping calculated at checkout.
  • Shipping within Australia
  • Bulk or International Orders? Contact Us
  • Secure payments
  • In stock, ready to ship
  • Inventory on the way

Organic liquid suspension of micronised calcium phosphate.

Plant available calcium and phosphate, together in a single, high analysis product, is not normally a possibility. The non-ionic nature of MMS products allows this highly productive combination. Phos-Life Organic™ is a high analysis source of micronised guano combined in a free-flowing suspension with fulvic acid. Calcium and phosphate are the two principle elements involved in photosynthesis and plant sugar production but it is not normally possible to combine them in a single fertiliser due to their incompatibility. Phos-Life Organic™ represents a rare fusion of these two elements in a plant available form.

Key Performance

  • An organic, high analysis source of calcium and phosphorus
  • Calcium and phosphorus are the governors of plant health and high brix levels
  • Tank compatible with most fertilisers

Growth Stage

  • Pre-planting
  • Planting
  • Vegetative Growth
  • Pre-flower, Flowering, Fruit Set & Fill


Typical Analysis W/V

Calcium (Ca)
24.56%
Silicon (Si)
10.73%
Total Phosphorus (P)  10.71%
Phosphorus (P) (citrate insoluble)
7.56%
Phosphorus (P) (citrate soluble) 3.15%
Phosphorus (P) (water soluble) 20 mg/L
Total Potassium (K) (as organic)
0.15%
Manganese (Mn)
1.66%
Iron (Fe) 0.86%
Magnesium(Mg) 0.34%
Zinc (Zn)
0.14%
Copper(Cu) 162 mg/L
SG 1.5
pH 6.5 - 8.5
Conductivity 1 - 5 mS/cm
Appearance Thick, mid-brown liquid, citrus odour


Application Rates

Soil Ameliorant or Fertigation: 10 – 30 L/ha as required. Use higher rate for soil amelioration.

Liquid Inject: 2 – 5 L/ha. Use a minimum dilution rate of 1 part product to 3 parts water. Rate will depend on crop, row spacing & soil type. Always consider N & P crop requirements for starters based on reliable soil test data.

Crop Application Frequency
Vegetables  1 L per 100 L water up to 5 L/ha equivalent
Apply weekly or as required
Orchards & Vineyards 1 L per 100 L water up to 10 L/ha equivalent Apply every 2 – 4 weeks or as required
Ornamentals & Turf
1 L per 100 L water up to 7 L/ha equivalent Apply every 2 – 4 weeks or as required
Broadacre Crops

 2 – 3 L/ha in 60 – 100 L water, depending on canopy closure

Apply as required
Pasture

2 – 3 L/ha in 60 – 100 L water

Apply as required
Spot-Spraying

50 mL per 10 L water

Apply as required


Home Garden Application: Dilute 45 mL per 9 L watering can and apply the diluted mix at a rate of 1 litre per square metre - this diluted mix can also be poured over foliage. Repeat every 2 - 4 weeks or as required.

Shake or stir well before use and maintain constant agitation. It is advisable to pre-mix, adding this product slowly while maintaining agitation in spray tank to prevent settling of solids. Will pass through 200 micron filter under ideal conditions, however, a coarse inline filter (500 microns/35 mesh) is recommended to ensure the delivery lines are free from particle contaminants from other sources. Where higher water rates are required for good foliar coverage, do not exceed maximum product rate per hectare. MMS products will leave a visible residue on leaves and fruit when used as a foliar. Avoid spraying close to harvest if produce is susceptible to staining. Sensitive foliage or plants should be test sprayed prior to full scale application. Frequencies are a guideline only and can be adjusted according to farm practices and/or in conjunction with crop monitoring. Ensure suitable spray conditions (e.g. temperature, humidity, wind-speed), prior to foliar application. Compatibility and/or performance cannot be guaranteed when combined with other products. Jar test for compatibility and spray test on small area before wide-spread use.

Store in a cool dry area out of direct sunlight. This product has been tested to store safely down to 5°C. Sedimentation may occur below 5°C. Do not pre-mix or store in diluted form. MMS products are very heavy and every care should be taken when handling these materials to avoid back injury

Note: Product in 1000 L tanks may weigh over 1 tonne. Forklift with 2 tonne lifting capacity is recommended.

Online orders are only available within Australia. For international orders, please contact us.

Click here for detailed shipping information.

Any recommendations provided by Nutri-Tech Solutions Pty Ltd (NTS)
or its Distributors are advice only. As no control can be exercised over storage, handling, mixing, application or use, or weather, plant or soil conditions before, during or after application (all of which may affect the performance of our program), no responsibility for, or liability for any failure in performance, losses, damages, or injuries (consequential or otherwise), arising from such storage, mixing, application, or use will be accepted under any circumstances whatsoever. NTS recommend you contact an Agronomist prior to product application. The Buyer assumes all responsibility for the use of any NTS products.

Recently viewed